Why do lawn mower ignition coils go bad?

The leading cause of premature failure of an ignition coil is due to a worn or bad spark plug ignition cable. A bad spark plug ignition cable will have a much higher than normal resistance. This high resistance causes a very high amount of voltage to be generated from your ignition coil’s secondary winding.

What are the symptoms of a bad coil on a small engine?

What Are the Signs of a Faulty Ignition Coil?
  • Loss of Power. This is one of the first symptoms of ignition coil failure.
  • Check Engine Light On.
  • Poor Fuel Economy.
  • Backfiring.
  • Misfiring Engine.
  • Hard Starts and Stalling.
  • Spluttering and Coughing Sounds.
  • Jerking and Vibrating.

How do I know if my lawn mower coil is bad?

How to test a lawnmower coil with a multimeter, step by step
  1. Step 1: Remove the ignition coil from the lawnmower.
  2. Step 2: Test the ignition coil using a multimeter.
  3. Step 3: Purchase a new ignition coil if the test fails.
  4. Step 4: Install the new coil.
  5. Step 5: Test the lawnmower with the new ignition coil.

What would cause a coil not to spark?

Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.

Table of Contents

Why do lawn mower ignition coils go bad? – Related Questions

What would cause an ignition coil not to fire?

If the ignition coil does not have spark, it’s time to check its wires. Use a test light to check the continuity on the signal wire and power wire on the ignition coil. If both wires are functional but the coil fails to produce spark, the ignition coil or the ignition control module is bad.

What is the common defect of a coil?

A couple of different buckling types can occur on a coil, but the most common is a center buckle, which is when the coil center is longer than the edges. This defect can create ripples in the center of the material.

What sends spark to the coil?

The low voltage primary circuit operates at battery voltage (12 to 14.5 volts) and is responsible for generating the signal to fire the spark plug at the exact right time and sending that signal to the ignition coil.

Why is my lawn mower not getting any spark?

If no spark appears, check for broken wires, shorts, grounds or a defective stop switch. Once you have confirmed that the stop switch is working, reconnect the spark plug lead.

What sends spark to the coil?

The low voltage primary circuit operates at battery voltage (12 to 14.5 volts) and is responsible for generating the signal to fire the spark plug at the exact right time and sending that signal to the ignition coil.

How do you diagnose a coil problem?

Here’s How To Diagnose and Test An Ignition Coil
  1. Plug the tester into the coil.
  2. Attach the ground wire.
  3. Plug in the coil connector.
  4. Adjust the spark gap to the correct measurement.
  5. Start the engine.
  6. If there’s spark, great, it works! If there’s no spark, it’s a bad coil.

How do you check an ignition coil for spark?

How do you test a lawn mower coil?

How long do ignition coils last?

Average lifetime of ignition coil is around 100,000 miles or more. It is not an easy worn out replacement car part but still could fail for variety of reasons.

How do you manually test an ignition coil?

Ignition coils have two circuits that require checking; primary and secondary circuits. Connect the multimeter to the negative and positive terminals of the ignition coil to get a primary circuit reading. If the multimeter shows a reading of 0 ohms, the ignition coil has shorted and needs replacing.

How do you test a coil with a screwdriver?

Can a ignition coil be weak and still work?

It’s important to remember that many times when a coil fails, it becomes weak. It still produces spark, and may still run the vehicle fine at times, but often under load, or acceleration, it can produce a misfire.

Is an ignition coil easy to fix?

You can replace a failing ignition coil fairly easily at home, but remember that you’re dealing with high voltages so must disconnect your battery before you start.

How do you fix an ignition coil on a lawn mower?

Leave a Comment