Place your spreader setting on a low setting (usually one-fourth of the spreader setting range or less). Spread the material over a 50 x 20-foot area (1,000 square feet). If there is material left over, increase your setting. If you come up short, decrease your setting.
What setting do I use on my Scott?
We recommend the following: If your spreader settings go from 1 to 10 (1 letting out the least and 10 letting out the most) you typically want to be around a 3 setting. If your spreader goes from 1 to 20, you should probably be around a 6 or 7 setting.
What do the numbers mean on a Scotts spreader?
The numbers stand for an application rate. A bag of commercial fertilizer will usually have numbers for where to set either broadcast or drop spreaders to get the recommended amount of fertilizer laid down.
How do you adjust a Scott spreader?
What setting do I put my fertilizer spreader on? – Related Questions
How do you use a Scott spreader?
How do you use Scotts Fertiliser spreader?
Select the spreader setting listed on the product bag. Holding the spreader level, walk steadily while squeezing the trigger in the handle and turning the handle. To obtain even coverage, spread half the required amount in a north-south direction, then the other half in an east-west direction.
What setting should Scotts spreader grass be set at?
Since settings will vary based on seed, it’s essential to verify this. For example, according to Scotts, the Scotts broadcast spreader settings for ryegrass seed should be set at setting 15 for new lawns and setting 5 for reseeding.
Determine the amount of fertilizer needed for 100 sq. ft. For example, the fertilizer bag weighs 25 lbs. and covers 5,000 sq.
Place this amount in the spreader.
Mark off the area. For a rotary spreader, use a 10-foot by 10-foot area (100 sq. ft).
Apply using the suggested setting.
How do you calibrate Scotts easy green spreader?
What setting should I put my Scotts drop spreader for grass?
They call for a 12.5 setting and 2 EA 25 LB bags to cover 5000 SF of lawn. Our spreader would run thru almost 2 bags for half the lawn at that setting.
What setting should I use on Scotts spreader for lime?
Pelletized lime should be applied every other year (approximately 15 lbs./1,000 ft²) once you have your soil pH to its optimum level, which is between 6.0 and 6.5.
Lime.
Spreader
Setting
Central Quality (Drop) 175, 185, 205
12
Scotts (Drop)
11.5
Scotts (Broadcast)
J
Earthway EV-N-SPRED
21
Is a drop spreader better than broadcast?
Drop spreaders are particularly valuable when you must be precise in the product’s release, whereas a broadcast spreader’s main function is to efficiently broadcast in all directions. Drop spreaders will also make sure you don’t waste any product as you’re spreading.
Do you overlap with a broadcast spreader?
Your current pass should spread product so it overlaps by a couple of feet the edge of the pattern of product spread from the previous pass (25% overlap).
What is Correct? Homeowner spreaders are generally calibrated to deliver the correct rate and pattern at a walking speed of 2.75 mph. Professional spreaders, which are more likely to be pushed by physically fit young males, are typically calibrated at 3.0 mph.
How do you spread fertilizer evenly?
How do you prevent stripes from fertilizer?
More specifically, the stripes are caused by not aligning the spreader as you make each pass. Most spreaders, either drop or broadcast, will have an “edge” where the fertilizer hits the lawn. These “edges” need to be aligned so that there is little overlap or gap between them.
What do the settings mean on a drop spreader?
In general, the smaller you set your spreader setting the smaller the hole and the slower the material releases from the hopper. There are many different brands of spreaders on the market, and, new or old, it is highly recommended to properly calibrate your spreader before the first use in the spring.
How many times should I fertilize my lawn?
A full feeding is recommended at least 5-6 times per year. You want to feed your lawn when it’s growing most rapidly. However, you should base the frequency on your climate and the type of grass you have. For example, cool season grasses can be fertilized in late spring, but only if necessary.
How much fertilizer do I use?
You should apply 10 pounds of the fertilizer per 1,000 square feet (five pounds from the table multiplied by the two pound recommendation). * When using a soluble inorganic nitrogen fertilizer a typical recommendation is to use only one pound of nitrogen per 1,000 square feet for a single application.
We use technologies like cookies to store and/or access device information. We do this to improve browsing experience and to show personalized ads. Consenting to these technologies will allow us to process data such as browsing behavior or unique IDs on this site. Not consenting or withdrawing consent, may adversely affect certain features and functions.
Functional
Always active
The technical storage or access is strictly necessary for the legitimate purpose of enabling the use of a specific service explicitly requested by the subscriber or user, or for the sole purpose of carrying out the transmission of a communication over an electronic communications network.
Preferences
The technical storage or access is necessary for the legitimate purpose of storing preferences that are not requested by the subscriber or user.
Statistics
The technical storage or access that is used exclusively for statistical purposes.The technical storage or access that is used exclusively for anonymous statistical purposes. Without a subpoena, voluntary compliance on the part of your Internet Service Provider, or additional records from a third party, information stored or retrieved for this purpose alone cannot usually be used to identify you.
Marketing
The technical storage or access is required to create user profiles to send advertising, or to track the user on a website or across several websites for similar marketing purposes.