What is the choke on symbol?

The choke on symbol for most small engines looks like a horizontal ( — ) or diagonal ( / ) line. It also can simply say ‘Choke’, ‘Full Choke’, or ‘Start’. The off symbol for most small engine chokes is represented by a vertical line ( | ) or the word ‘Run’.

When the choke is on is it open or closed?

Normally choke will be in open position, in which valve is parallel to the air flow, and has no effect on the air flow. When choke is actuated by mechanical or by pneumatic method, it rotates an angle restrict the air flow (closed position).

See also  Where does Governor spring attach on Briggs and Stratton?

What symbol is choke on Stihl?

Stihl chainsaws denote the choke position using a nearly horizontal squiggle between two vertical lines at the lowest position on the master control lever.

What is the choke on symbol? – Related Questions

How do you tell if choke is on or off on dirt bike?

What is choke mode?

What is a Common Mode Choke? A common mode choke is an electrical filter that blocks high frequency noise common to two or more data or power lines while allowing the desired DC or low-frequency signal to pass.

Which way is choke on a Stihl trimmer?

Which way is the choke on a Stihl leaf blower?

Which way is choke on Stihl hedge trimmer?

How do you use a Stihl choke?

STARTING YOUR CHAINSAW
  1. Depress the throttle lock and throttle, and move the control lever to full choke (i.e. moved to the limit of its travel).
  2. Firmly press the primer (if fitted) 2–3 times.
  3. Place the saw on the ground.
  4. Once the saw has ‘fired’, move the choke up to the “half-choke” position and pull over.

How do you start a chainsaw with a choke?

In either case, your goal is to get the fuel flowing and get your saw’s engine warm enough to fire.
  1. Set Your Chain Brake.
  2. Close the Choke.
  3. Press the Decompression Valve.
  4. Press the Primer Bulb.
  5. Set the Choke to “Run” or “On”
  6. Pull the Cord Again.
  7. Set the Engine to “Low Idle”

What is the safest way to start a chainsaw?

What is the proper way to start a chainsaw?

Should the brake be on when starting a chainsaw?

Check the Chain Brake

When engaged, the chain brake stops the chain from rotating around the saw’s guide bar. When using a chainsaw, you should always start it with the chain brake engaged so the chain does not move.

Why is it so hard to start a chainsaw?

#1 Dirty carburetor

This is easily the top culprit. In fact, anytime I run into a chainsaw, string trimmer, lawn mower or other small engine that won’t start, is hard to start or runs poorly, I suspect a dirty carburetor first – and it’s usually the case. Gasoline begins to break down in as few as 30 days.

Do you throttle when starting chainsaw?

Pull the starter handle until the engine fires. Push the choke (half-throttle) and pull again until the saw starts. Accelerate (rev) so that the engine idles and then release the chain brake.

How many pulls should it take to start a chainsaw?

With the choke in the “off” position, pull the engine’s crank cord through again. The engine should start in 1 to 3 pulls. Try it first without using the throttle control—unless recommended by the manufacturer.

Why does my chainsaw dies when I give it throttle?

The reason for this is usually some clogging in the carburetor or in some other area that resists the flow of air and fuel. To overcome this you should check the filters and if there is any thick oil deposited on the surface. Clean the filters and oil tank and that’s all. Your chainsaw would not die now.

Leave a Comment