CRAFTSMAN 42-in Deck Belt for Riding Mower/Tractors (0.53-in W x 96.5-in L)
How long is Deck Belt on 42 inch John Deere?
Dimensions
| Belt length (in.) |
103.7 |
42 in. |
| Fits Deck Size (in.) |
42 in. |
42 |
| Product Depth (in.) |
5.95 in |
1.6 in |
| Product Width (in.) |
15.2 in |
|
How tight should Deck Belt be on zero turn mower?
Apply pressure to the belt between pulley A and pulley B, and deflect the belt ½ inch. The gauge should read 10-15 ft-lb. If the reading on the gauge is higher, it is too tight, and if it is lower, it is too loose.
How do you put a Deck Belt back on?
How long is a 42 inch mower Deck Belt? – Related Questions
Which way does a deck belt go?
How do you tension a mower deck belt?
How do you put a deck belt back on a riding lawn mower?
How do you put a lawnmower belt back on?
How do you reattach a lawnmower belt?
Why does my new deck belt keep coming off?
There are lots of potential reasons for a mower deck belt that keeps coming off. It might be that the belt is damaged or worn, the belt could have stretched, one or more belt keepers could be bent out of place or there could be a damaged pulley or pulley bracket.
How many hours does a mower deck belt last?
There is no specific time length that mower belts need to be replaced. Some belts may last longer than others due to different operating conditions. One thing is for certain though, the more the mower is used, the sooner you will need to consider replacing the mower belt.
What is the most common cause of belt slippage?
Improper belt tension is the most common and obvious cause of slip, which generates unwanted heat. The friction that occurs when a V-belt slips in a pulley causes belt sidewalls to become glazed, and decreases gripping ability.
How long do mower deck belts last?
What’s the Expected Lifespan of a Mower Drive Belt? You should have no problem getting 3-4 years out of your lawn mower drive belt. However, you can extend the belt’s lifespan beyond this with the correct treatment and maintenance.
How do I know if my mower deck belt is bad?
Look at the belt edge that contacts the pulleys. If it appears shiny, glazed or burned, it will need to be replaced.
Is there a difference between a deck belt and a deck drive belt?
Both play a role in making the blades turn. The “Deck Belt” goes around the pulleys right above the blades on the deck and then to a double pulley. The “Drive Belt” on your mower goes from the transmission, around an Idler pulley then over to the double pulley I mentioned before.
How tight should a deck belt be?
Home and Garden Geek adds that you should be able to loop one or two fingers over the same belt when the tractor is off and the belt is “engaged” and pull it gently away from the pullies. This translates to one or two pounds of force. If you need more than two fingers, your deck belt may be too tight.
How do I know if my belt tension is correct?
Can you overtighten a belt?
An over-tightened belt can burn out any bearing that the belt rotates on, including alternator, power steering pump, A/C compressor, idler pulleys, etc. An over-tightened timing belt can ruin any pulley bearing it is connected with.
How do you adjust a belt tension?
What happens if belt tension is too high?
If the belt tension is too low, the belt will slip causing noise, extremely high temperatures and premature belt wear, all of which can lead to the poor functioning of the belt-driven accessories. If the tension is too high, this will cause excessive wear to the belt-driven accessories.