Turn the dial to Seasonal Adjust. Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen. Your ESP-Me is now restored to the factory default settings.
How do I reset my sprinkler controller?
How do you reset a Rainbird watering system?
Resetting a Rain Bird ESP-Me is easy. To reset the irrigation controller, all you need to do is turn the dial to ‘Seasonal Adjust’ then hold the left and right buttons down until the LCD display says ‘CLEARED’ then your ESP-Me irrigation controller has been reset.
How do you reprogram a Rainbird sprinkler system?
How do I reset my Rainbird control panel? – Related Questions
Why won’t my Rain Bird controller connect?
If you are unable to connect to the controller, try pulling the WiFi module out of the controller and re-inserting it, allowing it to boot back up again. It should be blinking green when you try to connect in the Rain Bird app.
Why is my controller not starting the watering cycle?
Check the valve.
Make sure the valve is operating normally by turning the solenoid 1/2″ turn counter-clockwise. Turning the solenoid will turn the valve on manually. Turn the solenoid clockwise until snug to turn off the valve. If the valve will not turn on manually, check the water supply to the valve.
How do I reconnect my Rain Bird?
- Open the Rain Bird App.
- Tap on the controller image that needs to be updated with the new WiFi name and password.
- Tap on the settings icon in the bottom right corner.
- Tap on “Network Settings”
- Tap on “Change WiFi Settings”
Why is my Rain Bird not rotating?
The poor rotation may be caused by debris trapped in the sprinkler head. Your water filter might need to be cleaned or replaced. Poor water pressure can affect sprinkler head rotation.
How do you cancel a program on Rain Bird?
To stop manual program watering: After starting a program manual run, you can press the “Skip Next” button (appears green when program is active) until all zones are skipped. The “Skip Next” button then turns grey indicating that the watering cycle is stopped.
How do you fix a Rain Bird sprinkler head that won’t rotate?
How to Do It
- Disassemble the sprinkler head.
- Take off the filter at the bottom of the head.
- Rinse the filter in a bucket filled with clean water to wash out debris.
- If this doesn’t work you’ll need to have the sprinkler head replaced.
- If it does work, make sure the head is properly adjusted when you re-install it.
How do you know if your sprinkler controller is bad?
How Do I Know If My Sprinkler Controller Is Bad?
- Uneven Spray Patterns. Is your sprinkler missing some specific parts of your garden or yard?
- Blank Display.
- Off-Schedule Watering.
- Inactive Controller.
- Low or High Water Pressure.
- Sprinkler System Is Inactive In One Zone.
- Sprinkler Isn’t Switching On/Off.
- High Water Bills.
Why won’t my sprinkler go back and forth?
Water Pressure or Water Volume
If the water level is too low, the distribution bar on an oscillating sprinkler may be unable to move at all, or it may move very slowly to the end of the cycle, then be unable to move past the pivot that sends it back in the opposite direction. (This varies a lot between models.
How do I check my Rainbird controller?
How long does a Rain Bird controller last?
Valves will give you 10 to 15 years of service, while controllers 5 to 10 years.
Why wont my Rain Bird sprinklers pop?
In most cases, if your sprinkler heads don’t pop up, it is directly related to water pressure. The most common problem we see causing sprinkler heads failing to pop up is another broken sprinkler head on the same zone.
How do I test my sprinkler controller?
How long should an irrigation controller last?
In general, they should last a good 40 years as long as they are protected from direct sunlight, which can damage them. Wires, however, must be replaced regularly as they can rust over time. You should also expect to replace your controllers every five to 10 years.
How do I manually test my Rainbird sprinkler system?
How do you manually test a Rainbird sprinkler system?
Why won’t my sprinkler system turn on manually?
Here are some common reasons why your sprinkler system won’t turn on: Lawn sprinkler control timer isn’t working correctly. Clogged or dirty sprinkler heads. Broken sprinkler heads.