Can I put a bigger bar on my Stihl MS170?

Stihl recommends that its MS 170, MS 171, MS 180, MS 181, MS 192 and MS 211 homeowner models be equipped with guide bars between 12 and 16 inches. The MS 250 and MS 251 models are equipped with larger 45 cc engines and are capable of driving an 18-inch bar.

How do I get more power out of my Stihl chainsaw?

Chainsaws can be modified to boost their performance and increase power. The basic idea is to increase the airflow through the engine. The most common method is muffler modification. This involves widening the muffler’s exhaust ports to improve the airflow at the exhaust.

Table of Contents

Can I put a 18 bar on Stihl MS170?

How do I tune my MS 170?

Can I put a bigger bar on my Stihl MS170? – Related Questions

What chain does a Stihl MS170 use?

8TEN Full Chisel Chainsaw Chain 14 Inch . 043 3/8 LP 50DL for Stihl MS170 MS180 023 MS210 009 010 MS201 (3 Pack)

What causes a Stihl chainsaw to bog down when accelerating?

The reason could be that you are using the Stihl saw at an altitude, or the carburetor adjustment might have slipped and required fixing. Bog down can also occur in the case of a dirty air filter, spark arrestor, or carburetor.

How do I tune up my Stihl chainsaw?

How do you cold start a Stihl MS170?

How do you advance the timing on a chainsaw?

How do you start a MS 171 chainsaw?

Is the Stihl MS 171 a good chainsaw?

Ideal for homeowners, the STIHL MS 171 is good for cutting firewood, felling small trees or completing clean up tasks.

Is there a trick to starting a Stihl chainsaw?

Do you throttle when starting chainsaw?

Pull the starter handle until the engine fires. Push the choke (half-throttle) and pull again until the saw starts. Accelerate (rev) so that the engine idles and then release the chain brake.

What happens if you rev a chainsaw with the brake on?

Don’t Put the Pedal to the Metal With the Brake On

If you hit the throttle hard while the brake is on, you can burn up the centrifugal clutch in just seconds. If the chain doesn’t spin when you squeeze the trigger, STOP and make sure the kickback brake isn’t on. If it’s on, release it and then hit the trigger.

See also  How long is the belt on John Deere 42 inch cut?

How many pulls should it take to start a chainsaw?

With the choke in the “off” position, pull the engine’s crank cord through again. The engine should start in 1 to 3 pulls. Try it first without using the throttle control—unless recommended by the manufacturer.

Is it best to run chainsaw at full throttle?

It is best to run a chainsaw at full throttle. Chainsaws use two-stroke engines that were designed to be run on full throttle. To get the best performance out of your chainsaw, always make cuts at full throttle.

Why does my chainsaw chain dull so quickly?

If your chain dulls quickly, then it could be a couple of things. Check your user’s manual to ensure that you are using the right sized file for your chain. Alternatively, you could be applying too much pressure when you file. This will create cutting edges that are too thin and dull quickly.

How do professionals sharpen chainsaw?

Is higher octane gas better for chainsaw?

Your chainsaw will need an unleaded, mid-grade gasoline with an octane rating of at least 89. This is one of the few times you’ll want to spend the money for premium gas. Unlike other small engines, most chainsaws us a high-performance engine. If the octane rating is not at 89, you risk knocking your engine.

Leave a Comment